#Electric quilt eq8 60 degree diamond update

We are going to edit this block so we can join the blocks together without having any overlap.

You can use the Rotate 180 degree tool for the triangles that need it.

Clone the triangle five times and arrange in the spaces between the squares.

You may have to practice a few times to get it in place. The drawing point starts at the top of the triangle. Draw it in the space between the squares.

Now, get the Equilateral Triangle shape.

You will need to rotate the squares using increments of 30 degrees and 60 degrees. Place the squares around the hexagon sides. Pick the square and move it over to one side of the hexagon. Use the Selected Segment/Patch properties to make sure it measures 4вЂі on each side. Click the Yellow tool to Center in Block.

You can go to the Selected Segment/Patch properties and make sure the hexagon measures a width of 8 and a height of 7.

Go over to the drawing grid and click and drag to draw a hexagon that is 8вЂі wide.

If you hover over the shape, the name of the shape will appear to guide you.

Under Patch Lines, check to use thicker lines when drawing a block.

Under Nudge Settings, change precision bar nudge increments to 1/32 inch.

Drawing Board Setup > General > Display.

#Electric quilt eq8 60 degree diamond update

Update the Worktable optionsВ by going to the Small Gear shape in the main left main toolbar.

Under Motif, in the Precision bar, change the block width and height to 16, Snaps horizontal and vertical to 32 and graph paper cells to 8 horizontal and vertical.

Notice the project name Untitledhas been replaced with Hexagon Layouts 3.

On the Create a new project tab, type in the project name field Hexagon Layouts 3.

OnВ the left side toolbar, click the New Project button.

Right now the project says Untitled вЂ“ EQ8. The project name appears at the top left of the EQ8 Window.